GEOENVIRONMENTAL CHARACTERS OF YELLOW (HUANGHE) RIVER SUSPENDED LOAD

Three important characters of the suspended load of the Yellow (Huanghe) River are discussed, i.e. its temporal fluctuation as a function of solar activity, its uneven spatial distribution along the main course and the inevitability of these phenomena as a natural earth process rather than a result of disturbed ecological system caused by human activity. Implications of this understanding with regard to the control of the Yellow River are also discussed.     

Study of cork (from Quercus suber L.)-wine model interactions based on voltammetric multivariate analysis

The cork from Quercus suber L. is the premium raw material used to produce wine-bottling stoppers; however, being a natural product, cork can be contaminated and attacked in different ways that could promote differences in its proprieties. A specific contamination is the defect known in the industry as “Mancha Amarela—Yellow spot” (MA). This cork shows modifications in its mechanical, structural and optical properties and is potentially able to cause off-flavours in wine. In this study, a new analytical approach is proposed for the rapid screening of cork-wine model interactions in order to determine if the cork were able to contaminate a wine. Cork samples classified as standard (S) and cork MA were put in contact with a wine model matrix. The model matrix was analysed by cyclic voltammetry and square wave voltammetry in function of different contact times. Considering that matrices in contact with cork S and MA exhibited different pH, the influence of this parameter on the distinction power was also evaluated. The data sets obtained from the different techniques were treated by principal component analysis (PCA) and PLS_Cluster. The major difference between samples S and MA is the occurrence of an important peak at ca. 580 mV in the MA voltammograms. This more positive peak may be assigned to lignin related phenolics; therefore, it can be proposed as a possible marker to follow lignin degradation.     

导数吸附伏安法同时测定柠檬黄及日落黄

色素日落黄和柠檬黄在ｐＨ８．２的硼酸钠－酸介质中均有良好的吸附伏安波，但波峰相互重叠，难以同时测定。本文提出以二阶导数法对日落黄和柠檬黄的重叠伏安波谱进行分析，以达到日落黄和柠檬黄同时测定的目的，方法简便快速。本法分析几种饮料中的日落黄及柠檬黄，结果满意。     

Assessment of corrosion resistance of surface-coated galvanized steel by analysis of the AC impedance spectra measured on the salt-spray-tested specimen

In the present work, corrosion resistance of surface-coated galvanized steel was quantitatively determined by an analysis of the alternating current (AC) impedance spectra measured on the salt-spray-tested specimen. To evaluate the corrosion resistance of the surface-coated galvanized steel, AC impedance spectroscopy was performed on the salt-spray-tested specimen previously exposed to salt-sprayed corrosive environment. From the analysis of the impedance spectra, the area fraction transient of white rust θ ₂(t) was theoretically derived from the equivalent circuit equation by using two fitting parameters. The values of the two fitting parameters were determined by fitting the empirical transient equations to the area fraction of the resin coating layer and to the total resistance obtained from the impedance spectra measured, respectively. From the analyses of θ ₂(t) for four kinds of surface-coated galvanized steels with various resin coating layers, it is indicated that as the values of the two fitting parameters decrease in the order of CP, GI, OD and OM (commercial trade names) specimens, the corrosion resistance increases in that order as well. Furthermore, from the quantitative comparison of the two fitting parameters with the polarization resistance of the upper resin coating layer R _p determined from the potentiodynamic polarization curve, it is suggested that the two fitting parameters decrease in value as well with increasing R _p.     

Synthesis and photochromic properties of novel yellow developing photochromic compounds

Two 1-thiazolyl-2-thienylcyclopentene derivatives, 1a and 2a, and a 1-thiazolyl-2-vinylcyclopentene derivative 3a have been synthesized in an attempt to obtain photochromic compounds which change the color from colorless to yellow, and have low photocycloreversion quantum yields and high absorption coefficients of the colored isomers. All of these compounds underwent reversible photochromic reactions. Compounds 1a and 2a in toluene solutions changed the color upon 313 nm light irradiation from colorless to orange and pink, in which absorption maxima were observed at 494 nm (ε=10,000 M⁻¹ cm⁻¹) and 525 nm (ε=8500 M⁻¹ cm⁻¹), respectively. On the other hand, the colorless toluene solution of 3a turned yellow upon irradiation with 313 nm light, in which the absorption maximum was observed at 416 nm (ε=17,100 M⁻¹ cm⁻¹). The photocyclization/cycloreversion quantum yields of 3 were 0.19 and 0.0014, respectively. The conversion from the open- to the closed-ring isomer of 3 in the photostationary state under irradiation with 313 nm light was close to 100%.     

Analysis of the Chemical Composition of Red Pigments and Inks for the Characterization and Differentiation of Contemporary Prints

Prints are one of the most popular artistic forms. They consist of an original matrix that is printed on a paper support. The stamps are part of a series, and each series is composed of a particular number of prints. Many contemporary prints are made using oil inks and synthetic pigments (reds and yellows). Inks are mainly composed of pigments (organic or inorganic) and a binding medium. The analysis of inks has the potential to facilitate and complement the identification of stamps of different origins.

Fourier transform infrared spectroscopy (FTIR) and Scanning Electron Microscopy-Energy Dispersive X-ray (SEM-EDX) are techniques that are typically available in museums and centers related to the study of works of art. Both can be classified as micro-destructive and provide complementary information about the organic and some inorganic compounds (FTIR), and the elemental composition (SEM-EDX). In this article, the two techniques were used to analyze the composition of red ink in prints. As a result of these analyses, it was possible to distinguish among nearly all of the pigments and inks, indicating that the composition of the red ink can be reliably used to differentiate between stamps of different origins in a series of prints.     

The use of different dispersive Raman spectrometers for the analysis of uranium compounds

The performances of three different Raman spectrometers were compared and evaluated as a suitable tool for the analysis of a range of uranium compounds with a view to application in nuclear forensics. These included uranium ore concentrates of different chemical composition and uranium dioxide in the form of powder and sintered fuel pellet. The three spectrometers are termed as ‘portable’ or ‘hand-held’ from Ahura Scientific (785 nm), ‘Senterra’ from Bruker (532 and 785 nm), ‘T64000′ from HORIBA Jobin Yvon (488.0, 514.5, 647.1 and 752.5 nm). Figures of merit such as sensitivity, signal-to-noise ratio and detection capability were compared. The portable Raman displayed fairly good sensitivity and process related impurities could be detected despite the miniaturisation but it was unable to measure darkly coloured powders such as calcined ore concentrates or uranium dioxide powder. The bench-top spectrometer Senterra had the best sensitivity for all the seven measured uranium compounds and the best signal-to-noise ratio for six of the compounds. Laboratory T64000 had the best resolution and at the same time resulting in the poorest sensitivity among the three spectrometers for all compounds measured. However, T64000 has very low level of noise therefore leading to better signal-to-noise that were comparable, if not better than the portable or Senterra. All industrial compounds measured in this study could not be measured with higher frequency laser thus impeding the observation of N–H or O–H vibration bands, of which the latter could be observed with laboratory synthesized material.     

Microbial Reduction of Lepidocrocite γ-FeOOH by Shewanella putrefaciens; The Formation of Green Rust

Dissimilatory iron-reducing bacteria (DIRB) couple the oxidation of organic matter or H₂ to the reduction of iron oxides. The bacterial reduction of a most common well-crystallised ferric oxyhydroxide, -FeOOH was investigated using DIRB Shewanella putrefaciens, strain CIP 8040. Experiments were conducted in the presence of neither organic buffer nor phosphate, with formate as electron donor, bicarbonate, and anthraquinone-2,6-disulfonate (AQDS, a humic acid analogue) that influenced the extent of ferric oxide bioreduction. The production of Fe²⁺ was followed with time. The solid phases obtained after bacterial iron reduction were analysed by transmission Mössbauer spectroscopy (TMS) and X-ray diffraction (XRD). Biogenic formation of green rust 1 compound, which contains carbonate anions, [Fe^II ₂Fe^III ₂(OH)₈]²⁺[CO₃ ^2–]^2– was observed. TMS was used to follow the evolution of the green rust abundance during the bacterial culture.     

Luminescence in GaN co-doped with carbon and silicon

GaN samples, containing various concentrations of carbon and doped intentionally with silicon, have been grown heteroepitaxially on sapphire using metal-organic-chemical-vapor deposition. Previous electrical and optical data, together with Density Functional calculations, have suggested that carbon is incorporated at acceptor and donor substitutional sites in this material; the relative importance of each is determined by the Fermi level position and the growth conditions. Here the luminescence behavior of these materials is examined in more detail, including spectral, temperature, and time dependences under ultraviolet light and electron beam excitation conditions. Particular attention is given to the commonly observed “yellow band” at , a blue luminescence at seen only in samples where carbon is the majority dopant, and ultraviolet bands near . Our data suggest that the latter two bands are both donor-acceptor related with the final state being the negatively charged state of a carbon atom substituting for nitrogen. In samples where carbon is the majority dopant, extended luminescence excitation at low temperatures results in large changes in the brightness of the yellow and blue luminescence bands. These effects are similar to other recent observations of luminescence metastability in high resistivity GaN, and we suggest that carbon plays a crucial role in this phenomenon.     

Simultaneous determination of silicate and phosphate in environmental waters using pre-column derivatization ion-pair liquid chromatography

A highly sensitive HPLC method for the simultaneous determination of soluble silicate and phosphate in environmental waters was developed, using ion-pair liquid chromatography preceded by the formation of their yellow α-heteropolymolybdates. The moderate-pH mobile phase enabled to use a highly efficient reversed-phase silica column. The pre-column coloring reactions at moderate-pH were reproducible for both silicate and phosphate in all quantification ranges with R.S.D.s less than 2% and 5%, respectively. The linear calibration lines between concentrations (mg-SiO₂/L and mg-PO₄/L) and peak area intensities were obtained for silicate and phosphate both with acceptable determination coefficients (r²) of 0.9999. The limits of determination for both analytes were 0.007 mg-SiO₂/L and 0.003 mg-PO₄/L, which were calculated theoretically using 10σ/slope. The four-digit dynamic ranges were obtained for 0.007-10 mg-SiO₂/L and 0.003-20 mg-PO₄/L. The developed method was applied for the analysis of tap water, river water, coastal seawater, well water, hot-spring water, commercial mineral water, and laboratory water. The results were very reasonable and acceptable from the environmental viewpoints, which were well correlated with those confirmed by the molybdenum-blue spectrophotometry.